FAAC Gate Installation Nationwide

FAAC Gate Installation in Orange: What to Know First

FAAC gate installation in Orange typically runs $2,800 to $7,500 for a complete setup, depending on the gate’s weight, length, and whether we’re working with an existing operator or starting fresh. Most FAAC jobs take one to three days from first measure to final test. We quote the price before any work starts, and we put it in writing.

Call (707) 754-0878

This page is for Orange homeowners who already own a FAAC operator or want one installed on a new or existing gate. If that’s you, call (707) 754-0878 and a live person will pick up, day or night.

How FAAC Products Fail - and How We Fix Them

FAAC builds a solid operator. We work on enough of them in Orange to know exactly where they give out and what’s worth fixing versus replacing. Here’s what we see most:

• S800H and C720 hydraulic operators with fluid leaks. These are big, powerful units built for heavy driveway gates. After years of Orange heat cycling, the hydraulic seals harden and weep fluid. The gate starts moving slower, then groans, then stops. We replace the seals, flush the hydraulic circuit, and refill with the correct FAAC-spec fluid before remounting the operator. It’s a half-day job that saves thousands over a new unit.
• E024S and 412 control boards killed by dirty power. Orange neighborhoods with older above-ground utility lines see voltage spikes during Santa Ana wind events. FAAC boards are sensitive to surges without a dedicated suppressor. The symptom is a dead keypad and no response from the remote, but power is clearly reaching the operator. We always install a surge protector on new FAAC board replacements and recommend one on every FAAC install we touch.
• Swing gate hinge wear on heavy ornamental gates. Many Orange homes built in the 1960s and 1970s still carry original wrought-iron gates that weigh far more than modern FAAC operators are rated to push. The operator works fine until the hinge pins wear and the gate sags a half-inch, forcing the motor to fight friction on every cycle. We weld or replace hinges, square the gate, and only then set the FAAC operator limits. Most gate contractors skip step one and burn out the operator in two years.
• Slow-motion 750 and 770 gate operators after gearbox oil failure. These are popular mid-range FAAC units on Orange residential driveways. The gearbox oil breaks down over a decade of use, and the gate crawls or shudders mid-travel. The fix is a gearbox rebuild with the correct lubricant, not a new operator. We do this on-site for most models when the housing is still sound.
• Photocell misalignment from shifting concrete. Orange’s clay-heavy soil moves with every wet winter and dry summer. Driveway slabs shift, and the FAAC photocells mounted on them drift out of alignment. The gate refuses to close or reverses mid-travel for no apparent reason. We re-align and often remount the sensors on posts set deeper than the original install, so the next rainy season doesn’t knock them out of line again.

Our FAAC Gate Installation Process

Every FAAC installation we do in Orange follows the same path. Here’s what to expect when you call:

1. 1
   Call and talk to a person. You reach a live technician, not a voicemail. We ask about your gate: swing or slide, approximate weight, existing operator, and what’s not working today.
2. 2
   On-site measure and assessment. We come out, measure the gate, check post integrity, hinge condition, and the power source location. We carry a torque gauge on every install because gate weight is the number that decides which FAAC operator will actually last.
3. 3
   Written quote before any work. We give you a fixed price on paper. It includes parts, labor, and any fabrication or welding needed. It does not change unless we find something structural you need to know about, and we discuss that with you before touching it.
4. 4
   Installation day. We mount the operator, run the power, set limit switches and force settings, and program remotes and keypads. If we’re replacing an old operator, we reuse a solid existing gate and hardware when it makes sense. We don’t sell you a new gate just because we’re there.
5. 5
   Full testing. We cycle the gate ten times minimum. We test obstacle detection with a real load, not just a hand wave. We test the manual release and the battery backup if one is installed. Victor Salinas walks every job before we leave.
6. 6
   Cleanup and the 90-Day Done Right Promise. We leave the driveway cleaner than we found it. If anything isn’t right within 90 days, we come back and make it right. No paperwork, no arguing.

What FAAC Gate Installation Costs in Orange

Here’s honest pricing for FAAC work in Orange, based on what we’ve quoted and completed this year:

• New FAAC swing operator on an existing gate: $2,800-$4,200 installed, including two remotes and a keypad.
• New FAAC slide operator on an existing gate: $3,200-$5,000 installed, depending on gate weight and track condition.
• Complete install with new driveway gate and FAAC operator: $6,000-$12,000. Steel ornamental gates cost more than aluminum. Custom fabrication adds time and material.
• Pedestrian gate with FAAC swing operator: $2,200-$3,400 installed, assuming a solid existing post system.
• Replacing a burned-out FAAC with a newer model: $2,600-$4,800, including uninstall, wiring, and programming.

What moves the price: gate weight and length, power run distance from the panel to the operator, post reinforcement if the originals are undersized, and whether you need battery backup. Call (707) 754-0878 for a free measure and written estimate. The price we quote is the price you pay.

Why Orange Homeowners Call Ironworks Gate Co. for FAAC Work

We’ve been doing this in Orange for over 42 years, since 1984. That means we’ve seen every FAAC model from the original 400 series to the current S800H, and we know which ones are worth rebuilding and which ones are ready for retirement. Victor Salinas grew up in Friendly Hills and studied welding and metal fabrication at Santiago Canyon College before starting this company. When a client’s grandson asks how the gate works, Victor explains it the same way he’d explain it to his own son, who’s been shadowing him on weekend calls for a few years now.

We’re an independent FAAC service provider, not a factory rep, and that’s a point of pride. We make repair decisions based on what’s best for your gate and your budget, not what a manufacturer wants us to sell. If a FAAC operator can be rebuilt honestly, we rebuild it. If not, we tell you straight. We also service LiftMaster, Mighty Mule, Ghost Controls, and DoorKing, so if your property has more than one operator brand, we handle all of them in the same visit. Every job is backed by our written 90-Day Done Right Promise. A live person answers the phone at (707) 754-0878, 24 hours a day, seven days a week.

FAQs